Green Homes News

GBA editor Randy Williams talks with longtime building science writer and retired GBA editor Martin Holladay. Martin reflects on building science, energy codes, and the future of housing

I'm preparing to frame my covered porch so I can start roofing my house in NY state. Before I do that, I need to figure out my concrete detail. I already…

Many HVAC problems start on the drawing board. Here are common design mistakes that lead to poor airflow, comfort issues, and inefficient systems.

My house (Climate zone 4A) has a small attic (200sf), which is encapsulated with 4" of polyiso above the roof deck, mineral wool batts in the rafter space and an…

I have a house built in 1960 in Climate Zone 4A.  I am looking to insulate or at least air seal the rim joist bays along with insulating the basement…

Integrated design in residential construction: why early builder involvement improves cost, quality, and coordination

Hi AllWe're in framing stage. As air barrier, I have Zip 1/2" on the attic floor. This goes underneath the knee wall bottom plates. The roof is not fully framed…

HiI'm looking to insulate and finish a basement room made of concrete blocks. The foundation exterior walls are covered with a delta membrane and damproofing (bitumen material-black stuff).The concrete block…

I happened to see this at a construction site today. One inch XPS directly over the studs, and then sheathing -- Zip board -- over the XPS.I thought it was…

GBA connected with industry leaders to discuss some new products that have come to market

Helping a friend who is installing an exhaust fan in a bath that never had one.  The duct from the exhaust fan will go to the attic and about 7'…

I am re-siding a house built in 1986 in the Cleveland, OH area. As part of the project, we are doing an energy retrofit. I am familiar with current building…

Hello  I started this thread back in November and since then I got a thermo imaging camera and shows a lot. I have an ice cold ring around the perimeter…